Pentair AUTOTROL Performa 263 - Regeneration time; Days to regenerate (740 time-clock controller only); Calendar override (760 on-demand controller only); Amount of brine used per regeneration

Installer Manual Performa 263-268 / LOGIX 740-760 - Programming
34 / 64 Ref. MKT-IM-011 / A - 15.06.2017
6.3.4. Regeneration time
Set the time when regeneration will take place.
6.3.5. Days to regenerate (740 time-clock controller only)
Set number of days between time-clock regeneration (regen frequency).
6.3.6. Calendar override (760 on-demand controller only)
Set number of days for calendar override on-demand controller.
6.3.7. Amount of brine used per regeneration
Set desired brine amount. 3 salt settings are available on 740 and 760 controllers:
• S – Standard Salt – 120 grams/liter of resin.
• H – High Salt – 200 grams/liter of resin.
• L – Low Salt – 40 grams/liter of resin.
A Press .
→ Regeneration time flashes.
B Adjust displayed time with and .
C Default setting: 2:00am.
D Press to validate the selection and advance to the next
parameter using or .
A Press .
→ Number of days flashes.
B Adjust displayed number with and .
→ Default number: 3 days.
→ Days can be adjusted from ½ (.5) to 99 days.
C Press to validate the selection and advance to the next
parameter using or .
A Press .
→ Number of days flashes.
B Adjust displayed number with and .
→ Default time for calendar override: 0 day.
→ Days can be adjusted from ½ (.5) to 99 days.
C Press to validate the selection and advance to the next
parameter using or .
A Press .
→ Setting flashes.
B Adjust displayed settings with and .
→ Default setting is "S" standard salting.
C Press to validate the selection and advance to the next
parameter using or .