Pentair AUTOTROL Performa 263 - Optical sensor and controller replacement

Installer Manual Performa 263-268 / LOGIX 740-760 - Maintenance
Ref. MKT-IM-011 / A - 15.06.2017 49 / 64
9.2.8. Optical sensor and controller replacement
No. Operation
Note
To remove the optical sensor, you first have to disassemble the camshaft. See “Motor and
camshaft replacement”, page 48.
A
The optical sensor (2) is clipped on the front edge, gently press on the clips to release the
optical sensor (2) from its location.
B Press the controller locking pad (4) and slide the controller (3) out of its position.
C Disconnect the cables from the controller by pressing on the clip and pulling them.
D Remove the motor, cables and optical sensor assembly to change them.
E Reverse above procedure steps to rebuild.
Caution
When refitting, always use the cables guide (1) to secure the cables. This will prevent the
cables from being crushed or cut when closing the cover or by the camshaft during
regeneration cycles.
A
A