COLORCASCADE
®
Color Pool and Spa Light Installation and User’s Guide COLORCASCADE
®
Color Pool and Spa Light Installation and User’s Guide
CONNECTING COLORCASCADE
®
LIGHT TO AN
INTELLIBRITE
®
CONTROLLER
12 VAC ColorCascade and IntelliBrite Lights
IMPORTANT! When installing 12 VAC ColorCascade lights, connect the lights to the
secondary 12 VAC output of the step down transformer, then connect the IntelliBrite
controller to the 120 VAC primary input of the step down transformer.
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
TURN power OFF at circuit breaker -
Always disconnect power to the pool light at the circuit
breaker before servicing the light. Failure to do so could
result in death or serious injury to installer, service person,
pool users, or others due to electrical shock.
To wire multiple 12 Volt ColorCascade Lights to an IntelliBrite Controller:
1. Neatly arrange the wires in the back of the outlet box.
2. Align the Controller with the screw holes of the outlet box. Secure the Con-
troller to the outlet box with the two (2) retaining screws.
3. Close the front door of the Controller.
Installing the IntelliBrite Controller in the Outlet box
The IntelliBrite Controller mounts onto a standard outlet box (22.5 cubic inches
minimum). After wiring the IntelliBrite Controller, check all wiring connections before
mounting the controller into the outlet box.
To install the IntelliBrite Controller:
Arrange
wires neatly
behind
Controller
To Next Page
Loading...
