Pentair FLECK 2850 SXT - Power Head And;Or Motor Replacement

Installer manual Fleck 2850 SXT - Maintenance
Ref. MKT-IM-030 / C - 12.05.2020 75 / 104
9.4.2 Power head and/or motor replacement
1. Using a flat screwdriver, unscrew(2) and open the cover(1).
2. Open the controller(3).
3. Using pliers, remove the circlip (11) and free the arm (4).
4. Using a flat screwdriver or a 11 mm wrench remove (10).
5. Using a 19 mm wrench, remove (9) the motor (6) and the power head (5).
6. Remove the microswitches (7) and cams (8), see Micro-switches replacement, and Cams
replacement [
→
Page81].
7. Replace the motor (6) and/or the power head (5).
8. Reverse above procedure steps to rebuild.