Pentair FLECK 5600 SXT - Entering Master Programming Mode; Display Format Mode (DF); Regeneration Flow (RF); Regeneration Control Type (CT)

Installer manual Fleck 5600 SXT - Programming
58 / 104 Ref. MKT-IM-013 / E - 23.09.2020
6.5.2 Entering master programming mode
1. Press and hold or until the programming icon replaces the
service icon and the parameter display reads TD.
2. Set the time to 12:01PM with or .
3. Press to validate the selection and return to the service mode, or wait
for 10seconds.
4. Press and hold and for 5seconds until the programming icon
replaces the service icon and the display format screen appears.
6.5.3 Display format mode (DF)
Select the unit of measure.
Options:
• GAL: U.S. gallons and 12-HourAM/PM;
• Ltr: litres and 24-Hour.
1. Press or to select the unit.
2. Press to validate the selection and move to the next parameter.
6.5.4 Regeneration flow (RF)
Select the regeneration flow.
Options:
• dF1b: standard downflow single backwash (standard);
• Othr: other;
• UFtr: upflow filter (for 5000filter);
• UFbd: upflow brine first;
• FLtr: filter, to be used with standard piston only (except5000);
• dF2b: standard downflow double backwash.
1. Press or to select t the regeneration flow.
2. Press to validate the selection and move to the next parameter.
6.5.5 Regeneration control type(CT)
Select the regeneration controller type.
Options:
• Fd: meter delayed;
• FI: meter immediate;
• tc: time clock;
• dAY: day of the week.