Pentair FLECK 5600 SXT - Current Flow Rate (FR); Peak Flow Rate (PF); Hours Since Last Regeneration (HR); Volume Since Last Regeneration (VU)

Installer manual Fleck 5600 SXT - Programming
64 / 104 Ref. MKT-IM-013 / E - 23.09.2020
6.7.2 Current flow rate (FR)
Info
The display is updated every second.
1. Current flow rate display (L/min or gpm depending on display format
programmed):
6.7.3 Peak flow rate (PF)
Info
The controller registers the highest flow rate (L/min) since the last regeneration.
1. Peak flow rate display:
6.7.4 Hours since last regeneration (HR)
Info
Shows the number of hours since the last regeneration, indicating the length of the
current service cycle.
1. Hours since last regeneration display:
6.7.5 Volume since last regeneration (VU)
Info
Shows the volume used since the last regeneration (L).
1. Volume since last regeneration display (L or Gal depending on display
format programmed):
6.7.6 Reserve capacity (RC)
Info
Shows the remaining reserve volume until next regeneration (L).
1. Volume until next regeneration display (L or Gal depending on display
format programmed):