Installer manual Fleck 5600 SXT - Maintenance
80 / 104 Ref. MKT-IM-013 / E - 23.09.2020
9.4.4 Piston and/or brine valve and/or seal and spacer kit replacement
1. Remove the power head, see Power head disassembly/replacement.
2. Using a flat screwdriver or an 8 mm wrench, unscrew (3) and remove the top plate (4).
3. Remove the brine valve (6) and/or the piston (5).
Caution - material
Risk of damage on piston due to wrench use!
Usind a wrench on piston rod coating will cause leakages.
4. Using a small hook, remove a seal (7).
5. Using the puller (1), remove a spacer (8).
6. Repeat the two previous steps for all the seals and spacers.
7. Lubricate each new seals(7).
8. Put back a seal(7) using the stuffer (2).
9. Put back a spacer(8) using the stuffer (2).
10. Repeat the two previous steps for all the seals and spacers.
11. Lubricate the piston o-ring(5).
12. Put back the brine valve (6) and/or the piston (5).
13. Using a flat screwdriver or an 8 mm wrench, fix the top plate (4) with the screws (3).
14. Rebuild the power head, see Power head disassembly/replacement.
Caution - material
Risk of damage due to wrong lubricant use!
Do not use petroleum-based lubricants such as vaseline, oils, or hydrocarbon-based
lubricants.
Use only approved silicone grease or soapy water!
9.4.4.1 Special tools needed
Item Part number Description Packaging
quantity
1 13061 Puller 1
To Next Page
Loading...
