Pentair Fleck 5800 LXT - 6 Programming; Display

Installer manual Fleck 5800 LXT - Programming
Ref. MKT-IM-005 / F - 30.04.2020 49 / 96
6 Programming
Info
If no button is pressed for 30seconds in the programming mode the controller returns
to Service mode.
During programming, the controller continues to operate normally monitoring water
usage and keeping all data up to date.
6.1 Display
1 Flow indicator • Flashes when outlet flow is detected.
2 Salt amount • g/l (Metric) or lbs (USunit).
3 Backwash length • min.
4 Time of regeneration/backwash
5 Time of day
6 Display position
7 Programming icon • Appears in programming mode.
8 Data display
9 Service icon • Appears in service mode;
• Flashes if a regeneration cycle has been queued.
10 Hardness • mg/l (Metric).
11 Days between regenerations/
backwash
12 Remaining days until
regeneration/backwash
13 Capacity remaining • m
3
(Metric).
14 Resin • l (Metric) or F in case of filtration.
15 Capacity remaining • Gauge.