Pentair Fleck 5800 LXT - Filter Time Clock Programming

Installer manual Fleck 5800 LXT - Programming
Ref. MKT-IM-005 / F - 30.04.2020 53 / 96
6.4.5 Filter time clock programming
6.4.5.1 Setting the tank capacity of filtration
Info
Setting the tank capacity of filtration must be done first. Anytime this parameter is
changed, other parameters (salt dosage, water hardness…) will be reset to default
value.
Set the tank capacity.
1. Press MODE until display position point to the Resin icon.
2. Press and hold or until the Programming icon appears.
3. Set the tank capacity with or , at F.
4. Press and hold to validate the selection and return to the service
mode.
6.4.5.2 Setting the time of backwash
Set the time of backwash.
1. Press MODE until display position point to the Time of Backwash icon.
2. Press and hold or until the Programming icon appears.
3. Set the time of backwash with or .
4. Press MODE to go to the next parameter, or press and hold to
validate the selection and return to the service mode.
6.4.5.3 Setting the backwash length
Set the time of backwash.
1. Press MODE until display position point to the Backwash Length icon.
2. Press and hold or until the Programming icon appears.
3. Set the backwash length with or , 1 to 30minutes.
4. Press MODE to go to the next parameter, or press and hold to
validate the selection and return to the service mode.
6.4.5.4 Setting the days between backwash
Set the days between backwash.
1. Press MODE until display position point to the Days Between
Regenerations icon.
2. Press and hold or until the Programming icon appears.
3. Set the number of days between backwash with or , 1 to 30.
4. Press MODE to go to the next parameter, or press and hold to
validate the selection and return to the service mode.