Pentair Fleck 5800 LXT - Power Head Disassembly;Replacement

Installer manual Fleck 5800 LXT - Maintenance
Ref. MKT-IM-005 / F - 30.04.2020 69 / 96
9.4.4 Power head disassembly/replacement
1. Remove the controller, see Controller replacement [
→
Page68].
2. Using a 6mm wrench or flat screwdriver, unscrew (2).
3. Using a 8mm wrench or flat screwdriver, unscrew (1).
4. Separate the power head (3) from the valve body (4).
5. Change the power head (3).
6. Reverse above procedure steps to rebuild. Mind the core marker and align the small holes of
the gears for easy reassembly.
Caution - material
Risk of damage due to bad mounting!
When assembling the gearing system (3) on the valve body (4), make sure to put the
brighter part of the piston axe (5) on the left as shown beside.
Tip
These operations need to be performed before any cleaning or maintenance procedure.