Pentair FLECK 5800 SXT - Regeneration Control Type (CT); Unit Capacity (C); Filter Capacity (V)

Installer Manual Fleck 5800 - SXT - Programming
Ref. MKT-IM-004 / A - 18.04.2017 53 / 92
6.5.6. Regeneration control type (CT)
Select the controller type.
Options:
• Fd: Meter delayed;
• FI: Meter immediate;
•tc: Time clock;
• dAY: Day of the week.
6.5.7. Unit capacity (C)
Set the unit capacity.
Note
The unit capacity parameter is only available if the controller type has been programmed for
volumetric regeneration.
Note
The unit capacity can be set from 0.1 to 9999 x 1000 °TH*m
3
, g as CaCO
3
equivalent.
6.5.8. Filter capacity (V)
Set the unit capacity.
Note
The unit capacity parameter is only available if the controller type has been programmed for
filter.
Note
The filter capacity can be set from 1 to 999.9 x 1000 L.
I Press or to select the regeneration flow.
J Press to validate the selection and move to the next parameter.
K Press or to select the controller type.
L Press to validate the selection and move to the next parameter.
M Press or to select the unit capacity.
N Press to validate the selection and to move the next parameter.
O Press or to select the unit capacity.
P Press to validate the selection and to move the next parameter.