Pentair FLECK 5800 SXT - Feedwater Hardness (H); Reserve Selection (RS)

Installer Manual Fleck 5800 - SXT - Programming
54 / 92 Ref. MKT-IM-004 / A - 18.04.2017
6.5.9. Feedwater hardness (H)
Set the feedwater hardness.
Note
The feedwater hardness parameter is only available if the controller type has been
programmed for volumetric regeneration.
Mandatory
Enter the feedwater hardness in °TH, ppm or grains of hardness for softener system.
Note
The feedwater hardness can be set from 1 to 1990 °TH, ppm, or grains.
6.5.10. Reserve selection (RS)
Select the reserve.
Note
The reserve selection parameter is only available if the controller type has been
programmed for volumetric regeneration.
Options:
• SF: Safety factor, in % of initial capacity;
• rc: Fixed reserve capacity (fixed volume in L);
• cr: Variable reserve capacity.
6.5.10.1 Safety factor (SF)
Set the safety factor.
Note
The safety factor parameter is only available if this option has been set in reserve selection.
Note
The safety factor can be set from 0 to 50% of the initial volumetric capacity.
Q Press or to set the feedwater hardness in accordance with display
format (DF), see chapter 6.5.3.
R Press to validate the selection and to move the next parameter.
S Press or to select the type of reserve.
T Press to validate the selection and move to the next parameter.
A