Pentair FLECK 5800 SXT - Diagnostic; Commands; Current Flow Rate (FR); Peak Flow Rate (PF)

Installer Manual Fleck 5800 - SXT - Programming
Ref. MKT-IM-004 / A - 18.04.2017 61 / 92
6.7. Diagnostic
Note
Depending on current settings, some displays cannot be viewed.
Note
If none of the buttons are pushed for 1 minute in the diagnostic mode the controller returns
to Service mode.
6.7.1. Commands
6.7.2. Current flow rate (FR)
Note
The display is updated every second.
6.7.3. Peak flow rate (PF)
Note
The controller registers the highest flow rate (L/min) since the last regeneration.
6.7.4. Hours since last regeneration (HR)
Note
Shows the number of hours since the last regeneration, indicating the length of the current
service cycle.
A Press and hold and for five seconds to enter the diagnostic mode.
B Press or to navigate in the diagnostic mode.
C Press to exit the Diagnostic mode at any time.
A Current flow rate display (L/min or gpm depending on display format
programmed).
B Peak flow rate display:
C Hours since last regeneration display: