What to do if my Pentair FLECK 7000XTR Control Unit is not responding after going into regeneration?
To address a Pentair Control Unit that's not responding after regeneration, verify the unit is configured correctly, paying attention to wiring and valve type. Perform a Master Reset by holding the Shift button and cycling power. Also, check and verify the choices selected in Master Programming Mode.
General| Operating Pressure | 20 - 125 psi |
|---|---|
| Display | LCD |
| Mounting | Top Mount |
| Warranty | 5 years |
| Valve Size | 1 inch |
| Control Type | Electronic |
| Timer Type | Electronic |
| Electrical | 120V AC, 60Hz |
| Cycle Settings | Adjustable |
| Bypass Valve | Optional |
Details on water pressure, electrical supply, plumbing, and softener location.
Step-by-step guide for installing the control valve and associated components.
Details on regeneration triggers and manual regeneration initiation.
Steps to access and enter the master programming menu.
Steps to enter, exit, and reset the master programming mode.
Steps to enter user mode and configure water hardness, override, and regeneration time.
Procedure for accessing the diagnostic programming mode.
General description of diagnostic mode and how to enter/exit.
Identifies and lists the parts of the control valve assembly.
Addresses timer error messages, problems, and provides corrections.
Diagnoses common control valve problems, causes, and solutions.
Addresses hard water delivery and meter measurement issues.
Visual diagrams illustrating water flow in different operational states.
To Next Page