Pentair FLECK 9100 SXT - Original Settings; Installation Settings; Hydraulic Settings; Electrical Settings

Installer manual Fleck 9100 SXT - Table of Contents
2 / 108 Ref. MKT-IM-004 / E - 06.10.2020
Table of Contents
1 Generalities..................................................................................... 6
1.1 Scope of the documentation ....................................................................... 6
1.2 Release management ................................................................................. 6
1.3 Manufacturer identifier, product ................................................................ 6
1.4 Intended use................................................................................................ 7
1.5 Abbreviations used...................................................................................... 7
1.6 Norms.......................................................................................................... 7
1.6.1 Applicable norms ................................................................................................ 7
1.6.2 Available certificates........................................................................................... 8
1.7 Procedure for technical support................................................................. 8
1.8 Copyright and Trademarks ......................................................................... 8
1.9 Limitation of liability.................................................................................... 9
1.10 Scan & Service application.......................................................................... 10
2 Safety .............................................................................................. 11
2.1 Safety pictograms definition ....................................................................... 11
2.2 Serial label location..................................................................................... 12
2.3 Hazards........................................................................................................ 12
2.3.1 Personnel ............................................................................................................ 12
2.3.2 Material ............................................................................................................... 13
2.4 Hygiene and sanitization ............................................................................. 13
2.4.1 Sanitary issues .................................................................................................... 13
2.4.2 Hygiene measures............................................................................................... 13
3 Description ...................................................................................... 14
3.1 Technical specifications .............................................................................. 14
3.2 Performance flow rate characteristics....................................................... 15
3.3 Outline drawing ........................................................................................... 16
3.4 Components description and location ........................................................ 17
3.5 System regeneration cycle.......................................................................... 18
3.5.1 Downflow regeneration cycle (5-cycles operation) ............................................ 18
3.5.2 Upflow regeneration cycle (5-cycles operation)................................................. 20
3.6 Options available on the valve..................................................................... 22
4 System sizing................................................................................... 23
4.1 Recommended Injector/DLFC/BLFC-Valve configuration ......................... 23
4.2 Sizing a softener (single unit) ..................................................................... 23
4.2.1 Parameters to be considered ............................................................................. 23
4.2.2 Determining the required volume of resin ......................................................... 24