Pentair FLECK 9100 SXT - Recommendations; Manual Regeneration; Manual Delayed Regeneration; Immediate Regeneration

Installer manual Fleck 9100 SXT - Operation
Ref. MKT-IM-004 / E - 06.10.2020 63 / 108
8.2 Recommendations
• Use only regeneration salts designed for water softening in accordance with EN973;
• for optimal system operation, the use of clean salt, free from impurities, is recommended (for
example salt pellets);
• do not use ice melt, block, or rock salts;
• the sanitizing process (both with liquid and electrochlorination) may introduce chlorine
compounds which may reduce the lifetime of the ion exchange resins. Refer to the technical
guides for resins in common use, providing necessary checks on the system.
8.3 Manual regeneration
Mandatory
The controller must be in service in order to enable this procedure!
8.3.1 Manual delayed regeneration
Info
This option is not available in mode FI.
8.3.2 Immediate regeneration
1. Press and hold for 5seconds to initiate immediate manual regeneration regardless from
the programmed regeneration control type.
8.3.3 To advance regeneration cycles
1. Press to pass to the next regeneration cycle.