Pentair FOLEO 5800 XTR - Operation; Display During Operation; Display During Regeneration; Controller Operation During Programming

Installer Manual Foleo - Operation
Ref. MKT-IM-038 / C - 15.11.2019 69 / 112
7. Operation
7.1. Display during operation
7.2. Display during regeneration
During regeneration, the regeneration cycle wheel shows the regeneration step the valve is advancing
to, or has reached (green), and the remaining duration in that step (1). Once all regeneration steps are
complete the valve returns to treatment position and resumes normal operation. The time remaining
in regeneration will be displayed on the home screen in hours and minutes.
Pressing the button during a regeneration cycle immediately advances the valve to the next cycle
step position and resumes normal step timing. The button is only shown when the valve is in
position and the motor has stopped.
7.3. Controller operation during programming
The controller can only be programmed when the valve is in service position. While being
programmed the controller continues to operate normally, monitoring water usage and keeping all
displays up to date. Controller programming is stored in non-volatile memory until reset.
Water treatment
wed
12:01 am
4.5
m
3
treatment
rapid rinse
backwash
tank refill
pause
draw
Regeneration
48 m
34 s
treatment
rapid rinse
backwash
tank refill
pause
draw