Installer Manual Foleo - Maintenance
90 / 112 Ref. MKT-IM-038 / C - 15.11.2019
8.5.7.6 Optical sensor replacement
No. Operation
A Remove the softener cover, see 8.5.2. Softener cover removal, page 77.
B Disconnect the wire from the motor to the optical sensor (4).
C Release the optical sensor support (1) by pushing it back and up as shown.
D Release the optical sensor (3) from its support (1) by pressing the clips (2).
E Change the optical sensor (3).
F Reverse above procedure steps to rebuild.
To Next Page
Loading...
