5
Assembly Instructions
Fig. 6
Fig. 7
Fig. 8
clamp sits in drive sleeve slot. Leave bolts and nuts finger tight. ***Some clamps
may not have an integral key. (Figure 7)
11. Apply an anti-seize compound to engine, motor, or pedestal shaft.
12. Install gas engine, c-faced electric motor, or pedestal into pump drive sleeve.
Align keyway of drive source with slot in drive sleeve. Do not rotate the pump
shaft during assembly. This may cause the shim to become dislodged.
13. Install (4) mounting bolts between pump adapter and gas engine, electric motor,
or pedestal. (Figure 8)
A. 2” pump – 5/16 x 24 screw – 11 ft.-lbs./ 14.9 Nm torque.
B. 3” pump – 3/8 x 16 screw – 20 ft.-lbs./ 27.1 Nm torque.
14. Alternately tighten clamp bolts to ensure even torque and balance.
A. 2” pump – 5/16 x 18 screw – 20 ft.-lbs./ 27.1 Nm torque.
B. 3” pump – 3/8 x 16 screw – 40 ft.-lbs./ 54.2 Nm torque.
15. Remove shim stock from pump outlet.
16. Pump and drive source should rotate freely.
To Next Page
Loading...
