Pentair HYPRO 1532C-6SP - Page 6

6
Disassembly Instructions
Fig. 9
Fig. 10
Fig. 11
Fig. 12
DISASSEMBLY – gas engine, C-faced electric motor, or pedestal
mount
1. Remove two-bolt clamp and bolts. (Figure 9)
2. Remove (4) mounting bolts between pump adapter and engine, motor, or
pedestal. (Figure 10)
3. Remove engine, motor, or pedestal. Drive source may need to be pried off.
Use caution not to damage drive source or pump.
4. Remove (6) nuts and lock washers holding adapter to pump. (Figure 11)
Note: Mechanical seal will be exposed after adapter is removed. Be careful
not to damage seal faces.
5. Gently pry the adapter flange off using a pry bar against tabs on the adapter.
(Figure 12)
6. Remove impeller, drive sleeve, mechanical seal assembly.
7. Remove paper gasket and discard. Remove any gasket residue from adapter
and pump faces.