Pentair HYPRO 9303C - Declaration of Incorporation

- 23 -
EC Declaration of Incorporation
Manufacturer’s Name: Pentair Flow Technologies, LLC
Manufacturer’s Address: 375 Fifth Avenue NW,
New Brighton, MN 55112, USA
Declare that the partially complete machinery described below conforms to applicable health and safety requirements of
Parts 1 of Annex I of Machinery Directive 2006/42/EC. This partly completed machinery must not be put into service until
the equipment into which it is to be incorporated has been declared in conformity with the provisions of this directive.
Condential technical documentation has been compiled as described in Annex VII Part B of Machinery Directive 2006/42/
EC and is available to European national authorities on written request. If a request is received, documentation will be
transmitted either electronically or by post. Clauses 1.1.4, 1.1.7, 1.1.8 Section 1.2, Clauses 1.3.5, 1.3.6, 1.3.7, 1.3.8.1, 1.3.8.2,
1.3.9, 1.4.1, 1.4.2.1, 1.4.2.2, 1.4.2.3, 1.4.3, 1.5.2, 1.5.7, 1.5.12, 1.5.14, 1.5.16, 1.6.2, 1.7.1.1, 1.7.1.2, 1.7.2, and 1.7.4.2 are clauses of
Machinery Directive 2006/42/EC that have not been met, but could be applicable and must be addressed during installation by
a third party.
Description: PENTAIR Pump
Type: Roller Pumps
Series Numbers: 1502, 1700, 4001, 4101, 6500, 7560, 7700
Type: Centrifugal Pumps
Series Numbers: 1442P, 9000, 9202, 9203, 9205, 9206, 9208, 9262, 9263, 9253, 9302, 9303,
9305, 9306, 9307, 9308
The following standards have either been referred to or been complied with in part or in full as relevant:
ENISO 12100 Machinery Safety General principles for design - Risk assessment and risk reduction
EN809-1998 + A1 2009 Machinery Safety Pumps and pump units for liquids - Common safety requirements
EN ISO 13732-1 Machinery Safety Ergonomics of the thermal environment
EN ISO 3744:2010 Acoustics Determination of sound power levels and sound energy levels of noise sources using
sound pressure
EN ISO 11202/A1 1997 Machinery Safety Noise emitted by machinery and equipment
EN 12162:2001+A1:2009 Machinery Safety Liquid pumps - Safety requirements - Procedure for hydrostatic testing
EN ISO 4254-6:2009 Machinery Safety Sprayers and liquid fertilizer distributors
97-68-EC + 2010/26/EU Gas Emission Non-road gas emissions
Name .……………...…………………………………………… Position …..……………………….…………
Signature …………………………………………..……………. Date …..……..……………………….………
Place of Signing……………………………………………………………………………………………………….........
QNET BV
Hommerterweg 286
6436 AM Amstenrade
The Netherlands
EC REP