Pentair IntelliChlor IC40 - Troubleshooting; Common Troubleshooting Issues and Solutions; Electrical Specifications; IntelliChlor Salt Chlorinator Electrical Details

INTELLICHLOR
®
Salt Chlorinator Installation Guide
Electrical Specifications
Circuit Protection: Two-pole 20 AMP device at the electrical panel.
IntelliChlor Salt Chlorinator Model IC20
Input: 90-130 VAC, 50/60 Hz, 220 Watts (2 AMP) or 220-240 VAC, 50/60 Hz, 220
Watts (1 AMP).
Output: 22-39 VDC @ 7.3 AMPS maximum from the Power Center.
IntelliChlor Salt Chlorinator Model IC40
Input: 90-130 VAC, 50/60 Hz, 220 Watts (2 AMP) or 220-240 VAC, 50/60 Hz, 220
Watts (1 AMP).
Output: 22-39 VDC @ 7.3 AMPS maximum from the Power Center.
IntelliChlor Salt Chlorinator Model IC40
Input: 90-130 VAC, 50/60 Hz, 220 Watts (2 AMP) or 220-240 VAC, 50/60 Hz, 220
Watts (1 AMP).
Output: 22-39 VDC @ 7.3 AMPS maximum from the Power Center.
6
Troubleshooting
Note: Turn off power to unit before attempting to service or repair.
melborPesuaCelbissoPnoitcAevitcerroC
neergrolhCilletnIehT
ehtnothgilrewop
.notonsilenaplortnoc
.neposiretne
CrewoPniesuF niamehtnodetacol,esufPMA01ecalpeR
.draobtiucric
.retneCrewoPotrewopCAoN 022roCAV011gnidivorp
sikcolcemityfireV
.evitcanehwretneCrewoPotCAV
rewoPniylcerrocderiwtonsdaelremrofsnaT
.retneC
ybecruosCAot
deriwsdaelremrofsnartyfireV
foedisninolacedmargaidgniriwotgnirrefer
.revocretneCrewoP
IMPORTANT: When using IntelliChlor
®
Salt Chlorinator with an
IntelliTouch
®
Control System, EasyTouch
®
Control System or
SunTouch
®
Control System, it is recommended to wire the
Power Center to the PUMP SIDE OF THE RELAY located in the
automation control system load center. This method does not
require a ground fault circuit-interrupter (GFCI) to protect the
circuit.