9
Note: Refer to page 3 where (parts index number) is shown
EasyTouch/IntelliTouch Control System Upgrade Kits Installation Guide
Circuit Breaker
Bracket Screws (8-32
x 3/8”)
Circuit Breaker Bracket
Screw (8-32 x 3/8”)
Optional Salt Chlorine
Generator (SCG)
SCG Ground Wire
5. Install the circuit breaker bracket with the circuit breakers onto the enclosure, and secure
it with two #8-32 x 3/8” screws (7).
6. Secure the circuit breaker bracket onto the back of the enclosure with #8-32 x 3/8” screw.
Be sure to reinstall the SCG ground wire (if present). See Figure 7.
Bracket
Screw
Bracket
Screw
Bracket Screw
12
Figure 8. Circuit Breaker Bracket Screws
Figure 7. Circuit Breakers Bracket
To Next Page
Loading...
