2
KREEPY KRAULY
®
Suction Side Pool Cleaner Installation and User’s Guide
Figure 4
Step 2: Attach the Seal
The cleaner comes equipped with one of two seals: the
universal Pleated seal (all pool types) or the flat seal
(concrete pools only). See Figure 5.
1. Locate the words “This Side Up” on the seal and
face toward the main body.
2. Slip the seal over the footpad (flat side facing pool
floor). Gently pull until the seal seats in the groove
on the other side. Be sure to install the seal with
the flat side down and contoured side face up
(the seals are not reversible).
3. The seal should rotate freely.
Step 1: Attach the Wings
1. Looking at the front right of the Kreepy Krauly
®
Suction Side Pool Cleaner, locate the “+” on the
right side of the body. See Figure 2.
2. Lay cleaner on its side so the “+” is facing upward.
3. Locate the wing with the “+” on the right inner wall
of the wing. See Figure 4.
4. Hold wing at an angle and place the left side into
the slot on cleaner, then the right side into slot,
being sure to hook the wing securely on the blue
tab inside the body of the cleaner. See Figure 3.
5. Gently pull on wing to ensure it’s secure.
6. Turn over cleaner to left side and repeat steps 4
and 5 by inserting the left wing marked “o” to the
left side of body marked “o.”
Figure 2
Figure 5
“+” Located
Here
Main BodyMain Body
(For Concrete Pools Only)
Pleats of
Pleated
Seal
The flat side of seal faces down to rest on the pool’s surface
Pleated/Flat Seals in their Grooves
Groove
Blue Tab
Figure 3
“+”
ASSEMBLING THE CLEANER
To Next Page
Loading...
