Pentair Pool and Spa Control System SunTouch - Intelliflo 4 X160 Warning and Alarm Conditions; Alarm and Warning LED Sequence; Suction Blockage

70
SunTouch Pool and Spa Control System Installation and User’s Guide
IntelliFlo 4x160 Warning and Alarm Conditions
The IntelliFlo 4x160 alarms and warnings are indicated by flashing LEDs on the control panel. For example, if a
“Drive Temperature” warning occurs, the LED will blink two times, then Off, then blink two times. This sequence
is repeated until the condition is cleared.
• Warning condition: If a warning condition occurs the pump will be continue to run but at a reduced
speed. The Green LED executes a sequence of blinks to indicate which alarm or warning has occurred.
• Alarm condition: If an alarm condition occurs the pump will drive stop running. The red LED flashes
continuously to indicate the presence of an alarm. The alarm LEDs will reset when the condition clears.
See “Pump Menu (12/13) on page 29 for setup information. For IntelliFlo troubleshooting information, see the
IntelliFlo 4x160 Installation and User’s Guide (P/N 357269).
Alarm and warning LED sequence
ehtemitforebmuN
knilblliwDEL
mralAnoitpircseDnoitcA
2gninraWerutarepmeTevirDerutarepmetevirdevissecxEsahnafrotomehterusnE.1
.noitalitnevrofaeraetauqeda
.looco
twolladnarotompotS.2
otdeepsrehgihatarotomnuR.3
.wolfriagniloocevorpmi
5mralanwonknUeruliafnortcelE.pmuptes
erotrewopelcyC.1
.evirdecalpeR.2
6mralAerutarepmeTevirDerutarepmetevirdevissecxEsahnafrotomehterusnE.1
.noi
talitnevrofaeraetauqeda
otdeepsrehgihatarotomnuR.2
.wolfriagniloocevorpmi
7mralAtuOrewoPwolegatlovylppuS.eg
atlovylppusreporperusnE
8mralAtnerrucrevOtnerrucevirdevissecxElacinahcem/diulfenimaxE.1
.daolrevofoecruosr
ofmetsys
dnarotomezigrene-eD.2
.yleerfsnipsrotomfienimreted
.evirdecalpeR.3
9mralAegatlovrevO ssubevirdnoegatlovevissecxEsdeepsneewtebgnihctiwsdipaR.1
segatlovevissecxeesuacnac
.ssubCDs'evirdehtno
.egatlovylppusr
eporperusnE.2