2
PROWLER® 930W Robotic Inground Pool Cleaner Installation and Maintenance Guide
STEP 4:
Connect Power Supply to Power Source
Connect the power supply to the desired
electrical source/outlet. See Figure 4.
RISK OF ELECTRICAL SHOCK OR
ELECTROCUTION: Connect only to a
grounding type receptacle protected by a ground-fault circuit-
interrupter (GFCI). Contact a qualified electrician if you cannot
verify that the receptacle is protected by a GFCI.
To reduce the risk of electrical shock, do
not use extension cord to connect unit to
electrical supply; provide a properly located outlet.
FIGURE 4
1. Ensure the power supply is positioned at
least 12 feet (3.5 m) from the pool.
2. Lower the cleaner into the pool by the handle
(see Figure 5).
Note: Never lower the cleaner into the
pool by the communication cable. This puts
unnecessary strain on the cable and could
damage the cleaner.
3. Gently tilt the cleaner from side to side or
turn it upside down to release trapped air.
See Figure 5.
FIGURE 5
STEP 5:
Placing the Cleaner in the Pool
Do not operate the pool cleaner if it is not
fully immersed in water. Operating the
cleaner out of water will immediately cause severe damage to the
cleaner and result in loss of warranty. Do not leave the cleaner in
the pool all the time. Always remember to turn the power supply
“OFF” and unplug it from the power outlet before removing the
cleaner from the pool.
STEP 3:
Connect Power Supply to Cleaner
Connect the communication cable to the power
supply.
Ensure the connector notch is lined up with
the corresponding groove in the socket on the
power supply. Tighten the cable nut clockwise to
secure the cable. See Figure 3.
FIGURE 3
To Next Page
Loading...
