Why Pentair RACER brush on front of cleaner is not spinning?
If the brush on the front of your Pentair Swimming Pool Vacuum isn't spinning, watch the front wheels while the cleaner is operating in the pool. The wheels and front brush should rotate simultaneously. Ensure the scrubber is free of tangled debris.
What to do if Pentair Swimming Pool Vacuum hangs at steps?
If your Pentair Swimming Pool Vacuum cleaner hangs at steps, ensure the front (large) wheels reverse approximately every 2-1/2 minutes.
What to do if Pentair Swimming Pool Vacuum will not climb?
If your Pentair Swimming Pool Vacuum cleaner will not climb, check the debris bag and empty it if it's full. Ensure proper water flow using the Flow Gauge and adjust the flow at the wall fitting if needed. Reposition the thrust jet to improve climbing. Keep in mind that the climbing ability depends on the pool shape and available water flow; it will perform better in pools without sharp angles or in the transition from the pool floor to the pool wall.
General| Type | Robotic |
|---|---|
| Pool Type | In-ground |
| Remote Control | No |
| Warranty | 2 years |
| Compatibility | All pool surfaces |
| Cable Length | 60 feet |
| Features | energy efficient |
| Cleaning Cycle | 2.5 hours |
Guidance on preparing for cleaner installation, including pool surface checks.
A list of essential checks and preparations before installing the pool cleaner.
Step-by-step guide for attaching the wall fitting and adapter.
Procedure for adjusting water flow using the flow gauge and wall fitting.
Steps for attaching the hose and debris bag to the cleaner head.
To Next Page