17 / 84
industrial heat tracing solutions
EN-RaychemNGC30UIT2Programming-AR-H5818602/16
Step 4D continued: This window shows the pop-up window prior to any Relay assignment
Fig. 2.9 Pop-up window prior to any Relay Assignment
• Press on the word “Available” to the right of #1 to assign Relay 1 as the output device for Circuit 1.
IMPORTANT: The window will always display which Relays are still available on this device for
Circuit assignment.
Step 4D continued: Press Enter after Relay assignment to return to the Setup window
Fig. 2.10 Device Address, Assign Relay Number window
To Next Page
Loading...
