64 / 84
industrial heat tracing solutions
EN-RaychemNGC30UIT2Programming-AR-H5818602/16
Ethernet Host
Fig. 3.45 System |Comm window (Ethernet Host Configuration)
IP Address/Subnet Mask Entry Field
By default, the IP Address and Subnet Mask are automatically inserted. However, if the IP Address
or Subnet Mask needs to be changed, click on the IP Address or Subnet window and then on the
EMACB1 icon.
To enter an IP address and Subnet Mask manually, click on the IP Address tab, select "Specify an
IP Address," enter the IP Address, the Subnet Mask, and Default Gateway.
IMPORTANT: The set-up parameters above should be provided by your network administrator. The
"Name Server" tab is not applicable for this application.
Transmit Delay Entry Field
This sets the time the NGC-UIT2 will wait after it receives a message before it replies.
Range: 0–5000 milliseconds
Default: 0
To Next Page
Loading...
