12
SANDSHARK
™
Automatic Vacuum Pool Cleaner Installation & User’s Guide
PROBLEM CORRECTIVE ACTION
If the SandShark
™
tracks in a repetitive pattern:
Check the pool return line water ow and redirect it as
necessary with a return line eyeball diverter (see “To
install the eyeball diverter”, on page 15).
Check the SandShark’s hose to be sure that it has
not become bent or kinked. Do not coil the hose, as it
will retain the coiled shape and reduce the cleaning
coverage.
To check the hose, lay each hose section at on the pool
deck (or another at surface) and look down the length
of the hose. It should be perfectly at and straight.
Replace any sections which are bent or kinked.
Check the oscillator for: damage; lost seals (there
should be 4 seals): obstructed seals (seals should slide
freely on the oscillator).
Be sure that the short, soft exible leader hose section
is the rst section in the hose assembly (next to the
cleaner).
SAVE THESE INSTRUCTIONS
TROUBLESHOOTING
To Next Page
Loading...
