SANDSHARK
™
Automatic Vacuum Pool Cleaner Installation & User’s Guide
2
Male Hose End
Female Hose End
Hose Assembly
For best results and to maintain proper operation, use only
original Pentair parts and hoses.
1. To connect the hose sections, wet the ends in the
pool water, then twist and push the female ends
onto the male ends.
2. Connect the leader hose to the cleaner swivel.
See Figure 3.
Note: The leader hose is 30 centimeters in length
and shorter than the other sections included in the
hose set. Failure to use this leader hose section will
hinder cleaner performance
3. The hose should reach from where the cleaner is
connected to the farthest point of the pool, plus one
section and the leader hose.
4. Make sure that all connections are snug.
5. The overall length of hose needed will be
determined by the distance from the point at which
you attach the hose to the suction port to the
furthest point in the pool, plus one length and the
leader hose. Refer to Figure 5.
Figure 2
Figure 3
The SandShark
™
Automatic Vacuum Pool Cleaner body is
shipped as one piece, making cleaner assembly a simple
and quick process.
Female Hose End Male Hose End
Leader Hose
Connect to Cleaner
Leader Hose with
red label marked
“Connect to Cleaner”
Leader Hose
marked
“Connect to
Cleaner”
Figure 4
ASSEMBLING THE CLEANER
Figure 5
To Next Page
Loading...
