Pentair SIATA V132 SFE-EV VIRIDION - System Description and Programming; Components and Bypassing; Access and Password Management; Setting Current Time and Day

User Guide Siata V132-SFE-EV
6 / 28 Ref. MKT-UG-009 / A - 21.12.2016
3.3. Description and components location
3.4. Bypassing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture
below.
4 . Programming
Mandatory: The access to the controller operating parameters requires the input of a 4-digit code (0000 by
default).
Note: The controller must be plugged to be programmed.
After 30 seconds without a button press, the unit returns to normal operation.
Note: Menus are displayed in a defined and incremental order.
While the parameters are being edited, the icon is on and blinking.
Entering password.
Changing the password.
Current time
A Press to enter the menu.
B Use to modify the digit and to pass to the next digit.
C Press to validate the password.
A Press repeatedly until the display shows End.
B While the message End is displayed, press once only.
C Use to modify the digit and to pass to the next digit.
D Press to validate the new password.
A Adjust the current time using to modify the digit and to pass to the next digit.
B Press to validate and switch to the next parameter.
UP button
DOWN button
LCD display
Injector
REGEN button
Drain
Twin pilots
Long manifold
Injector
Meter
Inlet
Outlet
External pilot connections
Short manifold
Normal
operation
In Bypass
In InOut Out
A
A
Siata_V132-SFE-EV_Multilingual.book Page 6 Lundi, 27. mars 2017 3:09 15