Pentair Siata V132 - System Description and Controls; Bypassing the System; System Programming; Basic Programming Steps

User Guide Siata V132-SFE
6 / 28 Ref. MKT-UG-003 / A - 14.10.2016
3.3. Description and components location
3.4. Bypassing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture
below.
4 . Programming
Note: The controller must be plugged to be programmed.
After 30 seconds without a button press, the unit returns to normal operation.
4.1. Basic programming
Note: Menus are displayed in a defined and incremental order.
While the parameters are being edited, the icon is on and blinking.
Display format change
Time of day
Day of the week
A Press to enter the menus sequence.
B Adjust the format to be displayed with and .
C Press to validate the selection and advance to the next parameter.
D Adjust the time with and .
→ Time flashes.
E Press to validate the selection and advance to the next parameter.
F Adjust the day with and .
→ Day flashes.
G Press to validate the selection and advance to the next parameter.
A
UP button
DOWN button
LCD display
Injector
Inlet (quick connection)
Regen button
Outlet (quick connection)
Closed drain
Twin pilots
Long manifold
Injector
Meter
Inlet (threaded
connection)
Outlet
(threaded
connection)
Drain
External pilot connections
Short manifold
Normal
operation
In Bypass
In InOut Out
A
A
A
A
A
A
A
A
A
SUTUMO WE TH FR SA
A
A