Pentair STA-RITE INTELLIFLO3 VSF - Troubleshooting; Drive LED Indicators; Troubleshooting Chart

19
INTELLIFLO3™ VSF / INTELLIPRO3™ VSF Variable Speed and Flow Pump Installation and Maintenance Guide
Drive LED Indicators
Each button on the drive;
CONNECT, ON/STOP and
QUICK CLEAN features an
LED indicator.
Refer to the table to the right
for a list of LED behaviors
and what they are indicating.
= Solid LED
= Blinking LED
= Pulsing LED
TROUBLESHOOTING
Always disconnect power to the pump at the circuit breaker and relieve pressure in the ltration system before servicing the pump. Failure
to do so could result in death or serious injury to serviceman, pool users or others due to electric shock. Do NOT attempt to adjust or
service without consulting your dealer or a qualied pool technician. Read the entire Installation and Maintenance Guide before attempting
to use, service, or adjust the pool ltering system or heater.
Troubleshooting Chart
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Connection Issue -
Pump is O󰀪ine Alert
Pump is not receiving power
Ensure the pump is receiving power.
If the pump is receiving power, the ON/STOP button will
illuminate.
Home internet service is out or
inaccessible
Conrm that the home router is active and connected to
the internet.
Intermittent WiFi or network
connection
1. Restart the home router. This can clear up many
typical home networking issues.
2. Cycle power to the pump.
Disconnect power to the pump at the main breaker,
Wait for 1 minute and reconnect power.
3. Check the signal strength in WiFi Settings of the
Pentair Home App.
If the signal strength is insu󰀩cient, refer to the Poor
WiFi Signal section of this troubleshooting chart.
Bluetooth
®
connectivity issues
1. Stand closer to the pump when operating via
Bluetooth
®
.
2. Restart the Pentair Home app.
3. Adjust the pump antenna.
4. Ensure smartphone permissions are given to the
pump.
LED BEHAVIOR INDICATES
CONNECT
Green
Pulsing Attempting to establish WiFi connection
Solid Active WiFi connection
Blue
Blinking Attempting to establish a Bluetooth
®
connection
Solid Active Bluetooth
®
connection
Yellow
Pulsing Pump requires provisioning
Blinking Pump update in progress
Magenta/Pink
Solid Automated control is active
Pulsing Connected to automation and in service mode
ON/STOP
Green
Solid Pump running
Blinking Priming cycle
Pulsing Pump in Thermal Mode
Red
Solid Pump disabled
Blinking Alarm detected
Green/Yellow Blinking Warning detected
Yellow Solid Pump is idle
- Troubleshooting Continues on the Next Page -