Pentair SunTouch - System Start-Up and Testing; Start-Up Procedures; System Testing

57
SunTouch
®
Control System Installation and User’s Guide
Accessing the SunTouch
®
Control System Motherboard
The SunTouch
®
Control System motherboard provides connectors for three auxiliary relays, valve actuators
and sensors.
To access the SunTouch Control System Power Center electronics compartment:
1. Loosen the retaining screw on the front panel. Open the hinged front panel to access the electronics
compartment.
2. Proceed with:
• Installing Auxiliary Relays, page 58
• Installing the Valve Actuator, page 60
• Installing and Connecting Temperature Sensors, page 61
• Connecting SunTouch Control System to a Gas Heater, page 62
3. After all electrical connections have be completed, close the front panel and secure it with the
retaining screw.
Retaining screw
Front panel
SunTouch
®
Control System Power Center (Shared Equipment System)