Pentax IQZoom 115G - Page 16

2 Place the film cartridge in the film chamber by
fitting its flat side on the top of the rewind shaft
first and then slide the top end of the film
cartride into the camera.
3 Pull the film leader out far enough from the car<
tridge to reach the take-up spool. Align the tip of
the film with the film leader end mark #.
4 After the back cover is closed, the film auto¬
matically advances to the first ^me.
14 X Slack No !
O Flat Yes !
Notes;
• Ensure the film is placed properly between
the film guides.
• If there is dirt on the film detector O, film
cannot be wound properly.
• Ensure the film is taut as illustrated on the
illustration. Take up any slack in the film
by pushing it back into the cartridge.
• If the end of the film leader is extremely
bent, straighten it or cut off the bent por¬
tion.