Pentax IQZoom 135 M - Page 41

Exposure control:-Programmed auto-exposure control with multi (6) metering system, Range; EV10 - EV18
at 38mm WIDE, EV14 - EV20 at 135mm TELE in Auto or Daylight-Sync Mode (ISO 400),
EV5 - EV18 at 38mm WIDE EV6.5 -EV20 at 135mm in Slow-Shutter-Speed Mode (ISO
400), Automatic exposure compensation in a backlit situation.
Plash: - B uilt - in flash with red-eye reduction mode, Automatic discharge In low lighting and back¬
lighting situations in auto mode, Flash ON = Day - light Sync/Slow - Shutter - Speed Sync
(up to 2 sec.), Flash - OFF Mode, Bulb - Sync 1/2 sec. - Imin.
Flash effective range: — o.8 (2.6ft) - 7.6m (25ft) (38mm WIDE), 1.08 (3.5ft) - 3.6m (12ft) (135mm TELE) (ISO 400film
Flash recycling time: — u sed).
Power source: - A pprox. 5 sec. under Pentax testing conditions.
Battery life: _ O n e 3V lithium battery (CR - 123Aor the equivalent)
Approx. 13rolls of 24exposure film when 50% of shooting uses flash (under Pentax test¬
ing conditions)
Battery exhaustion - ( d — m ) appears on the LCD panel. Shutter is locked when ( C M ) JS blinking.
warning:
Size & Weight: - 1 1 3 . 5 (W) x 66.0 (H) x 50.0 (D) mm (4.5” x 2.6” x 2.0”) 235g (8.3oz) without battery
DATE MODEL
Date mechanism
Imprinting mode: -
Size & Weight: —
-Crystal quartz controlled; LCD with digital clock, auto calendar up to 2030. Possible to
imprint both standard and panoramic format frames.
-“Year, Month and Day”, “Day, Hour and Minutes. blank, Month, Day and Year” or
“Day, Month and Yeaf^’.
-113.5 (W) x 66.0 (H) X 50.0 (D)mm (4.5” x 2.6" x 2.0") 235g (8.3oz) without battery
REMOTE CONTROL
Remote control:-Infrared wireless remote control, 3-seconds delay shutter release. Effective range: Closer
than 5m when projected from the camera’s front.
Power source for-One lithium battery CR1620 (replaced by Pentax Service facility)
Remote Control:
Size & weight for-22.0 (W) x53.0 (L) x 6.5 (D) mm (0.9” x 2.1” x 0.3”), 7g (0.2oz) including battery
SPEcIfICATIONS are subject to change at any time without notification OR ANY OBLIGATION
ON THE PART OF THE MANUFACTURER. 39