Pentax K-5 II S - Page 126

en
:::::;
0
0
~
:::s
(Q
-n
r:::
:::s
n
r+
0
:::s
t/)
4
Press
the
shutter
release
button
halfway.
The
following
indicators appear on the status screen.
((~))
Shake
Reduction
On
+ Horizon
Correction
Off
~
Shake
Reduction
Off+
Horizon Correction
Off
(<-8~
Shake
Reduction
On
+ Horizon Correction
On
({~~
Shake
Reduction
Off+
Horizon Correction
On
• The
Shake
Reduction function
will
not
fully
work (for about 2 seconds) right
after turning
on
the camera
or
restoring from Auto Power
Off.
Wait for the
Shake
Reduction function to become stable, and then press the shutter
button gently.
If(<~>)
appears
in
the viewfinder when you press the shutter
release button halfway, the camera is ready to take a picture.
•
The
Shake Reduction function is available with any PENT AX lens compatible
with this camera. However, when the aperture ring is set to a position other
than the
A
(Auto) position for a lens with
a
A
position or a lens without an
A
position is used, the camera will not operate unless [27. Using Aperture Ring]
is
set to [Permitted]
in
the
[C
Custom Setting 4] menu. Set this beforehand.
In
such cases, however, some functions
will be restricted. Refer to
"Using the
Aperture Ring"
(p.299) for details.
When the
Focal Length Cannot Be
Automatically
Detected
The Shake Reduction function operates by obtaining the lens information
such as focal length.
If the camera uses
aDA,
DA
L,
D FA, FA
J,
FA or F lens, the lens information
is automatically
obtained when the Shake Reduction function is activated.
Set
the focal length if you use a lens whose information such as focal
length cannot be
automatically
obtained (p.297).
•
The [Input Focal Length] setting screen does not appear when using a lens
whose information such as focal length can
be automatically obtained.
•
When using a lens without the
A
position on the aperture or with the aperture
set to a position other than
A,
set [27. Using Aperture Ring]
in
the
[C
Custom
Setting 4] menu to [Permitted]. (p.299)
•
The effect of Shake
Reduction is influenced by the shooting distance as well
as focal length information. The
Shake
Reduction function may not work as
effectively as expected when shooting at close ranges.