•
11[1)
)>
"'C
"'C
('D
:::s
0.
)("
Problem
Autofocus
does not
work
The focus
cannot be
locked
The AE Lock
function does
not operate
The
built-in
flash
does not
discharge
The
USB
connection
with
a computer
does
not
work
properly
Shake
Reduction
does not work
Cause
The focus mode is
set to
MF
The focus mode is
set to
AF.C
The exposure
mode
is
set to
•,
B
or
X
mode
The exposure
mode
is
set to
•
mode
The
USB
connection mode
is
set to [PTP]
The
Shake
Reduction function
is off
The
Shake
Reduction function
is
not set
properly
Shutterspeedistoo
low
for the
Shake
Reduction function
to
be
effective when
panning or shooting
night scenes, etc.
The subject is too
close
Remedy
Set
the focus mode switch to
AF.S
or
C.
(p.1
08)
Autofocus
is
not
locked
(focus lock)
when
the focus mode
is
set to
AF.C
(C).
The
camera
will
continue focusing on the subject
while
the shutter release
button
is
pressed
halfway. If
there
is
a subject that you wish to
focus on,
slide
the focus mode switch to
AF.S
and use the focus
lock.
(p.1
08)
Set the exposure mode to any mode other
than
• (Green),
B
(Bulb
Exposure) or
X
(Flash
X-sync Speed).
Only
~A
(Auto
Flash
Discharge) and
~~
(Auto Flash+Red-eye Reduction) are
available
for the flash
mode when the
exposure mode
is
•
(Green). The
flash will
not discharge when the subject is bright
in
these modes.
In
the exposure modes other
than
.,
only
the
flash
mode that
discharges every time the
flash
recharges
is
available.
Try different exposure modes.
Set [USB
Connection] to
[MSC]
in
the
['
Set-up 2] menu. (p.279)
Set [Shake
Reduction] to
(<~>)
(On)
in
the
[0
Rec. Mode 4] menu. (p.122)
If
a lens
for which the
focal length
information cannot be obtained
is
used, set
the
focal length
in
the
[Input Focal
Length]
screen. (p.124)
Turn off the Shake
Reduction function and
use a tripod.
Move away from the subject, or turn off the
Shake
Reduction function and use a tripod.
To Next Page
Loading...
