•
~
C)
CD
E£
::I
CQ
en
....
•
Do not use the provided battery charger
D-BC90
to charge batteries other
than
D-LI90.
Charging other batteries may cause damage or heating.
• Replace the battery with a new one
in
the
following
cases:
-
If
the indicator
lamp blinks
or does not
light
after the battery is inserted
correctly
-
If
the battery starts to run down more
quickly
even after being charged (the
battery may have reached the end
of
its service life)
The maximum charging time is approximately 320
minutes (it depends on
temperature and remaining battery power.) Charge
in
a location
where the
temperature is between
ooc
and
40°C.
~
Inserting/Removing
the
Battery
Q.
1
• Do not open the battery cover or remove the battery
while
the power is on.
• Insert
the battery
correctly. Inserting the battery
incorrectly
may cause a
camera breakdown. Wipe the
electrodes
of
the battery with a soft dry cloth
before inserting.
•
Be careful
as the camera or battery may become hot when the camera is
used continuously for a
long
period
of
time.
•
Remove the battery when you
will
not use the camera for a
long while. The
battery may
leak
and damage the camera if
left installed
during
prolonged
periods
of
non-use.
If
the removed battery
will
not be used for six months or
longer,
charge the battery for about
30
minutes before storing
it.
Be sure to
recharge the battery every six to
twelve
months.
•
Store the battery
in
a location
where the temperature will remain
below
room
temperature. Avoid locations
with high temperatures.
•
The date and time may be reset if you
leave
the battery out
of
the camera for
long
periods
of
time. If
this occurs,
follow the procedure described
in
"Setting
the Date and
Time"
(p.62) to set the current date and time.
Open
the battery cover.
Lift the battery cover
unlock knob, turn it
towards
OPEN
(CD)
to
unlock,
and then
pull
the cover open
(®).
To Next Page
Loading...
