Pentax MZ-5 - Film Transport Motor Assy. (0-S200)

•
6- 6. TY -CN L- Dl.7x3.5
A37, A38, A36 (Battery cover switch)
MO (Battery positioning seal)
TY-CNL-Dl.7x2.5
A35 (Battery contact piece +)
[ Note of assembly ]
•
Mak~ sure that the Batt. cover switch
(A36, A37) should be contacted com pl etely.
6-7. TY-CNL-Gl.7x2.5
• O-S200
(Film transport motor assy.), Cl2, 2 screws
[ Note of assembly ]
• Green lead wire (FM+)
of 0- S200 should be
located at Al4 (Strap
hook, tight) side.
6-8. TY-CNL -Dl. 7x5.0 x2
•
Cl (Bottom mech. plate), Cll,
Cl3 and related parts.
[ Note of assembly ]
• Align Cl5 (Sprocket gear) and
0- Cl6 ( ... switch gear assy.) before
installing as
shown in the diagram right.
6- 9. Al83 x2 (Cover retainer screw C)
A27 (Data contact cover)
· T61 (Data
flexible P.C.boal'd)
TY- CNL- Gl.7x3.5
A6, O-A4 (Back cover key assy.)
T64
(Bock cover key SW P.C.board)
6- 10. RlOl (DX contact co ver)
TY-CNL-Dl.7x4.5
x2
RllO (DX contact piece assy.)
Al9 (Film cartridge
sjXing)
lf • (HM t .o I 4 .) 0 ty .. CH .M t.o I .. )
IC.109.>0lf ~0 IC. f09J4Jll
6-ll.T Y-CNM2.0x4.5x4 Al
4
ii @4 AlS
• Al4, Al5 (Strap hook, tight/left) .........._<!$> ~
[ Other parts ]
A33 (Battery contact piece cushion)
Al8 (Film position marker)
AlO (Back cover shaft receptacle, top)
All (Back cover shaft receptacle, bottom)
A29 (Film car1lidge guide)
~
_ \
• A46 (Shutter light sea l) .. ·
c:7"""" .. .;1:;:·
• A47 (Light seal) ':./
A47 . A46
0- A20 (Film retliner plate assy .)
27250
TY• CHL• 0 t, J • 3.0
IC.111t~ll
Al83
4
1~27
\
T61
R 101 DTIH•~I ~ur::'\
"'hf! ~~ Al9
\j] /r ""0
tT • CHL•Ol ,l' 1 4)
I C. t t ltO I t
11/24