Pentax MZ-5 - Top Cover Assembly; Disassembly of Flash Cover (Q1); Accessory Shoe Operations; Shutter Speed Dial and Release Button

7. Top cover assy.
7- 1. Disassembly of Ql (Flash cover)
Set the flash at pop- up position, then remove 4 screws.
[ Note ] Do not make any damage
to the Top cover
by using a driver.
7-2. Unsolder the T51
( ... flexible P.C.board).
TY - CNM1.7x4.0
1200 (Pop- up switch)
TY-CNL- Dl.7x2.5
A370 (Lead wire holder)
•
TY-CNL-Dl.7x3.0
A368, A367, 0-A365 (flash hook lever assy.)
TY-CNL - Gl.7x3.0 x2
Q7, Q8, Q9 (Flash pop- up spring)
A363
x2, O-A362 (Arm assy.) x2
Peel 4 lead wires from the Top cover,
then remove
Q2 (Flash frame).
[ Note
of assembly ]
Stick on DT(7x18) and DT(7xl0).
··· fig. @
Arrange the lead wires. · · · fig. © and @
When replacing QlOO, apply silicone to the
place as shown in the fig. © .
Check the flash pop- up switch ON/OFF.
7- 4. Accessory shoe
... fig.®
7-5. Shutter speed dial
... fig.(/) .
7- 6. Main SW l
ever and
Release button
... fig.®
7-7. Exposure-
compensation dial
... fig.®
( Note of assembly ]
Aligning A312
(Dial-
mbber ring) and the
dial (A311, A331),
install A312 on
the dial.
Other paits ]
A302 (LCD window)
6
~A323
~A322
~O·A321
~-A330
i
4n &-TW-CH\.•01 , 7•) .0
® IC.. l lTUOll
· A303 (Light seal frame)
12/24
27250