79
3
Taking Pictures
5
Press the 4 button.
The frame appears on the display.
When the camera detects a person’s face, the Face Detection function is
activated and the face detection frame appears (p.69).
In this mode, a set number of pictures can be taken automatically at a set interval
from a set time.
1
Use the four-way controller (2345) to select (Interval
Shot) from the Capture Mode Palette.
2
Press the 4 button.
The current interval shot settings appear for approximately 1 minute. To take
pictures with the current settings, go to step 10.
3
Press the 4 button while the settings are displayed.
The [Interval Shot] setting screen appears. [Interval] is marked with the frame.
At shipment, the camera includes 3 default frames for each aspect ratio (4:3
and 16:9).
Optional Frames
The optional frames are stored in the CD-ROM supplied with the camera. To use
these frames, copy them from the CD-ROM (p.155). These optional frames are
deleted if the files on the built-in memory are deleted with a computer or if the built-
in memory is formatted.
Adding a Frame to a captured image 1p.153
Taking Pictures at a Set Interval (Interval Shot)
Interval 10 sec. – 99 min.
Set the camera to take pictures at intervals. The
intervals can be set in increments of one second from
ten seconds to 4 minutes, or in 1 minute increments
from 4 to 99 minutes. You cannot set the camera to
take interval shots at less than ten seconds.
Number
of Shots
2 shots – number of
recordable images
You can set this to up to 1000 shots. However, it
cannot exceed the number of recordable images.
Start Delay 0 min. – 24 hours
You can set 1 minute increments for the first 59
minutes and 1 hour increments from there. If the
start time is set to 0 minutes, the first picture is taken
as soon as the shutter release button is pressed.
To Next Page
Loading...
