Pentax Zoom 70-R - Correcting the data

Correcting the data
• Each time you press the SELECT button Q, a different
category of digits in the LCD display flickers. Press
the SELECT button # until you reach the flickering
digit(s) which you wish to change. The dlgit(s) will
move in the following order as you press the SELECT
button 9-
Date; Year Month Day
Time: Hour Minute — : (Second)
• Press the ADJUST button O to change digits of the
specified category you chose with the SELECT button
Digits Increase by one each time you press the
ADJUST button Q. If you keep it depressed, the digit
will advance continuously after a second or two.
• Date and time are indicated as follows;
Year - 87 - 19 (1987 - 2019)
Month = 1 — 12
Day = 1-31
Hour = 0-23
Minute = 00 — 59
Adjusting ‘'Year>Month-Day”
1. Make the diglt(s) to be changed corresponding to
day, month, or year flicker by pressing the SELECT
button O-
2. Press the ADJUST button Q to adjust the digit(s).
3. Press the SELECT button 0 again to set the digitfs)
you’ve changed and stop the flickering.
Adjusting "Hour-Minute>: (Second)”
1. Make the digit(s) to be changed corresponding to
hour or minute flicker by pressing the SELECT button
0 . The flickering allows precise fine-tuning of the
internal clock to the beginning of a specified minute.
2. Press the ADJUST button 0 to adjust the digit(s).
3. To adjust the time to the beginning of a minute, press
the ADJUST button 0 while is flickering, then
release it in synch with a time signal.
4. Press the SELECT button 0 again to set digits
you've changed and stop the flickering.