Pentax Zoom 90 - Page 17

When you press the shutter release button half-way, the
lamps O O shown above glow or flicker.
O Green lamp: When it glows you can take a picture.
When it flickers, you cannot
e Red lamp: When it glows, flash is ready to fire. When it
flickers, flash is being charged.
Note:
• If the green lamp flickers in the ordinary or macro set¬
tings, the subject is either too close or too far. Adjust the
camera-to-subject distance so that the green lamp
glows, then release the shutter.
When the LCD panel is as shown above, the camera is in
the Auto and Single-Frame Shooting modes. These
modes are used for ordinary picture-taking situations. If
the LCD panel displays indications other than those
above, press the mode/drive clear ( C) button to reset the
LCD panel to appear as above.
@