Pentax Zoom 90 - Page 37

To select the shooting interval, while pressing the drive
button, press the zooming lever to the left or right until the
required interval time appears on the LCD panel. The
preset interval time Is 60 seconds. (When the zooming
lever Is kept depressed, the interval time will be fast
forwarded.)
After the selection, press the shutter release button; the
first frame will be exposed 3 seconds later. Then the rest
of the film will be automatically exposed according to the
interval time selected.
Notes:
• Use a tripod when shooting in the Interval Shooting
mode.
• The focus will be fixed at the first frame, and the self-
timer lamp starts flickering 3 seconds before the shutter
is released.
• When in the Interval Shooting mode, the interval
shooting mark ( INT ) flickers on the LCD panel and
the remaining time of the interval is also displayed.
• When in the Bulb or Bulb-Synchro mode, interval
shooting with an interval time between 2 and 60 minutes
can be performed; interval shooting with the Interval
time between 10 and 60 seconds is not possible.
• To cancel the Interval Shooting mode after It has been
activated, press the mode or drive button.
• To restore the Auto and Single-Frame Shooting modes,
press the clear ( C) button.
• To switch to the other modes, press the drive button
twice In quick succession.
• The exposure counter appears on the LCD panel when
the shutter release button is pressed.