Pentax Zoom 90 - Page 40

Correcting the data
1 Each time you press the SELECT button Q, a different
category of digits in the LCD display flickers. Press the
SELECT button O until you reach the flickering digit(s)
which you wish to change. The digit|s) will move in the
following order as you press the SELECT button O
Date. Year — Month — Day
Time: Hour — Minute ^ :(Second)
2. Press the ADJUST button 0 to change digits of the
specified category you chose with the SELECT button
O’ Digits increase by one each time you press the
ADJUST button O-you keep it depressed, the digit
will advance continuously after two or three seconds.
3. After the correction, press the SELECT button O to
make the data imprinting possible (the bar mark (—)
appears on the LCD panel).
• When the data is being corrected (the data flickers on
the LCD panel), the data cannot be imprinted even if the
shutter is released.
• Date and time are indicated as follows;
Year = 87 - 19 (1987 — 2019)
Month = 1—12
Day = 1 — 31
Hour = 0 — 23
Minute = 00 — 59
• The flickering "r” allows precise fine-tuning of the
internal clock to the beginning of a specified minute. To
do so, press the ADJUST button (3) while is flickering
and release in sync with a time-signal.