Pentax Zoom 90 - Battery Exhaustion Warning

When the batteries are nearly exhausted, the battery mark
(d'-IZI) appears on the LCD panel to warn you. Replace
the batteries as soon as possible. When () starts
flickering, no operations can be performed.
The battery mark () appears during operation of the
shutter release button or zooming lever.
Notes on replacing the batteries:
• Make sure there is no film loaded. Switch off power by
setting the main switch to (O) before replacing the
batteries.
• If the batteries are replaced with film already loaded, the
camera enters the starting mode. It will assume the film
has been just loaded and will advance several frames.
(When the loaded film is near its end, | f ) or ( - - |
might appear on the exposure counter of the LCD
panel. In such cases, press the auxiliary rewind button
to activate rewinding.)
• Batteries power both the camera’s main unit and the
data-imprinting section. After replacement, confirm that
the data on the LCD panel is correct
Refer to page 34 for data correction.