Pentax ZX-M - Page 17

THE SHUTTER CURTAINS ARE FINE-PRECI¬
SION MATERIAL. DO NOT TOUCH THEM WITH
YOUR FINGERS OR ANY OTHER OBJECT
WHILE LOADING FILM.
• If you have pulled out too much film, push it back
into the cartridge to reduce the slack.
• The DX information pins in the film chamber are
used to read film speed. Keep them clean and free
from scratches. To remove smudges, wipe them
gently with a soft, dry cloth.
13
3
3 Align the film leader with the film leader end
mark O as shown.
• Make sure that the film perforations properly
engage on the sprocket teeth ©.
• Make sure that the film leader is positioned under
the film retainer O as shown in the illustration.
GENERAL
OPERATION