Pentax ZX-M - Page 18

GENERAL
OPERATION
4
X Film loaded with slack No!
• If the film is not loaded
properly, [ Q. f ] on
the LCD panel blinks,
indicating that the film
is not loaded properly.
Open the back cover
and load the film once
again.
4 Close the back cover and, If you have not
already done so, set the main switch to the
[ ON ] position. The fiim automatically
advances to the first frame.
• Check that [ / ] and [ Q. ] are displayed on the
LCD panel.
•The film counter indication advances one each
time the shutter is released.